Steps for installing electric rollers

(1) Fixed support installation: the electric drum shall be reliably grounded; the lead-out line shall be protected by metal hose or other means from the junction box, and the hose shall be fixed on the rack; it shall be allowed to be installed within a range of less than 5 degrees on the basis of a horizontal position; if the inclination exceeds 5 degrees, the internal structure shall be treated specially. For electric rollers with a power greater than 18.5KW, if lifting is needed, the material of the bearing should be steel.

(2)Installation of electric drum without support (2) Installation of electric drum without support: the axis of drum body should be perpendicular to the center of belt conveyor, the square flatness of supporting shaft head should be matched with the long groove of the mounting plate on the frame, and the clearance should be between 0.2mm and 0.3mm, which should not be too large; some models can not be matched with junction box, so the power leads from the frame. After the elbow comes out, hose protection should be added; the electric roller should be reliably grounded.

(3) installation of electric rollers with backstop: only allowed to operate in a specified direction.

1, the application scope and characteristics of TDY75 type oil cooled electric roller

1.1 It can replace the external drive device of motor-reducer type which is widely used at present. It is used to form belt conveyor. It can convey bulk materials such as coal, ore, sand, cement, flour, etc. It can also convey jute bags, equipment and other finished products.

1.2 the structure is simple and compact and occupies small space.

1.3 good seal, suitable for dust concentration, wet and muddy workplace.

1.4 convenient maintenance, safe operation and long service life.

1.5 less energy consumption, and easy to achieve centralized control.

1.6, it can meet all kinds of requirements such as backstop, brake, glue and so on.

2. Working conditions

2.1 the ambient temperature is 15 +40 and C.

2.2 no more than 1000 meters above sea level.

2.3 the temperature of conveying material should not exceed 60 C.

2.4 voltage 380V, frequency 50Hz.